Izdelki za stojalo za vezenje (2)

Nurge Table Adjustable Embroidery Stand 190-4 The Nurge adjustable wooden embroidery table stand is made from hard beechwood, fine sanded and polished for a super smooth natural wood finish. These products are the crafters choice for quality. The embroidery stand allows easy embroidering using both hands. It can be used as a table-top stand or from a chair The stand has 4 adjustable joints including the final hoop holding knuckle joint, that will pivot to the angle you wish for maximum comfort whilst creating your next masterpiece! The stand will hold mot sizes of hoop diameter and will fully extend out to a height up to 53cm (21″). The base is 39cm (15″) x 21cm (8.3″). The stand is also good for holding tapestry frames up to 75cm (30″).

The Nurge adjustable wooden embroidery seat stand is made from hard beechwood, fine sanded and polished for a super smooth natural wood finish. They are the crafter' choice for quality. The seat embroidery stand allows easy embroidering using both hands. It can be used as a table-top stand but is ideally designed to be a seat stand by sitting on the lower base tucked under your legs allowing comfort and creativity at the same time! The stand has a height adjustable joint (minimum height 32cm ( 12.6″), maximum height 48cm (19″), plus a hoop holding knuckle joint that will pivot to any angle so that you can find the optimum height, distance, and angle depending on your hoop size for maximum comfort while creating your next masterpiece! The stand will hold many sized hoops ~ Typically 100mm to 310mm (4″ to 12″) and hoops up to and including 16mm deep. The hoop can either be clamped top to bottom or from the inside to the outside with the screw tightening down on the hoop.